Tankless Hot Water Heater Installation Instructions

After tightening both fittings at the water heater open several hot water faucets and allow water to run though the water heater for at least 2 to 3 minutes.

Tankless hot water heater installation instructions.

6 rv53i rv53e operation and installation manual this water heater will attempt to provide hot water at the temperature setting even when the water flow is varied or when more than 1 tap is in use. Call rheem service or your local plumber to arrange an inspection. Tk 540p nih 199 000 btu natural gas indoor condensing ultra low nox download manual. Disconnect heat source from old water heater as follows.

Attach the gas supply line to the shutoff valve. This page has general replacement instructions. Back to product literature instruction manuals commercial gas commercial electric commercial heat pump commercial tankless commercial oil fired commercial boilers pump expansio. The water heater can deliver water at only one temperature setting at a time.

Make sure you have the purge and drain valves on hand since they do not come with many water heaters. Tk 540p pih 199 000 btu liquid propane indoor condensing ultra low nox. Product support looking for out of production models. Visit the product support section.

Going on holidays heavy flow of hot water discharging from valve vent or drain line immediately turn off the electricity supply to the water heater. Tronic 6000c series wh17 wh27 installation manual. Electric tankless water heaters manuals bosch tronic electric tankless water heaters. User manuals rheem water heater operating guides and service manuals.

For and electric water heater simply unplug the appliance from the wall outlet. Look for a hex shaped plug at the top of the water heater. For gas propane make sure the supply valve is closed this is usually determined by the direction of the handle to the valve sitting either in the same direction as the line open opposite the direction of the line closed. Download 1164 rheem water heater pdf manuals.

On some water heaters the anode rod is attached directly to the hot water nipple. Connect the water heater connect the shutoff valve and the sediment trap to the water heater following the manufacturer s instructions. The available temperatures for a given model are provided below. You simply untighten the plug and remove it.

This process purges all the air from the water lines and must be performed prior to turning on the power at the unit.