Taking Up Carpet And Sanding Floorboards

Of carpet and cut it into easy to handle strips photo 1.

Taking up carpet and sanding floorboards.

Just grab the carpet with pliers and pull. I liked the dascopro prybar set amazon affiliate link since the bars were the perfect compact size for getting under the tack strips. You can most definitely sand and finish wooden floorboards yourself. Remove the 3 foot wide carpet sections from the tack strips by shaking the carpet in a back and forth motion while pulling it up from the surface of the floor.

Utility knife for cutting up carpet and or padding into more manageable size strips for rolling up and removing from the room. From there it s a simple matter to roll up the carpet and haul it. Carpet is great but there are always areas that just. Be aware the project generates quite a bit of dust and could spread out over two or three days but your ultimate reward will be a great looking wood floor that enhances the beauty of your home.

Either way it may be time to tear up the carpet and restore the hardwood flooring. It would also end up being a false economy as even if you don t count the impossible amount of time it would take to do you would probably also end up going through such a ridiculous amount of sandpaper that it may even end up costing you more than to hire a machine. Pull the carpet up along this strip and keep going in strips until all the carpet is up. Sand a small inconspicuous area and see.

Let s be real kids are hard on carpet. Before we see i m not taking the whole credit for myself started the first time i did a lot of research about sanding the floorboards and read some horrible stories how difficult dirty dusty noisy and very time consuming it is. This is a project i ve wanted to tackle for a while and recently got the go ahead from our landlords. Today i m going to teach ya ll how to pull up carpet and refinish those gorgeous wood floors that may be hiding under your carpet.

And you can do it all in just one weekend. Can i sand floorboards with a hand sander. No need to clear the room of furniture and clutter at this stage. You can see part 2 stain seal reveal here.

Believe me i tried. The carpet will be connected to the concrete surface via a series of wooden strips to which the carpet is tacked. Pull back a corner of the carpet using a pair of pliers. To remove the carpet you cut a slit in the carpet near a wall grip the carpet and pry it up off the tack points along one side.

Then grab the carpet by hand and continue to pull it up along an entire wall. Fold back about 3 ft. Even the most horrible looking floorboards can scrub up well. Prybar for pulling up the carpet tack strips.