Swollen Wooden Floor

One of the most common problems related to excess moisture is called buckling wood flooring gets separated from the subfloor that is very often accompanied by cupping or swelling.

Swollen wooden floor.

Depending on how swollen the wood gets the wooden planks might even pop out of their tongue and groove fastenings. It s possible to repair damaged hardwood but you need to correct the moisture. It is for this reason that solid wood floors need an expansion gap. Wood floor cupping can be avoided or fixed by following a few simple steps.

Floor buckling happens most often after a floor has been flooded for an extended period of time. Luckily there is an easy solution to dealing with swollen hardwood floors. If solid wood floors are fitted without an expansion gap problems which can sometimes be severe are likely to arise. Buckling occurs when the wood flooring actually pulls up from the subfloor lifting several inches in one or more places.

When humidity is high the wood expands. To do this remove the baseboard or quarter round and then take the flooring apart one row at a time until you reach the swollen section of flooring. Solid wood flooring takes in moisture when there is a high level of humidity in the air and then the flooring lets that moisture go when the humidity in the atmosphere reduces again. You must to locate and inspect the area where the floor is swelled up.

Floor buckling is the most extreme reaction to moisture in a hardwood floor. Water damage can have severe consequences that results in wood floor swelling or buckling from the humidity. Wood is porous which means when it is exposed to moisture it can absorb that moisture and swell. Fortunately this is not a common occurrence.

Causes of buckling floor as i mentioned above the only culprit is always moisture caused by. Excessive job site moisture. Unfortunately one day you find that your wooden front door expanded and it will no longer close smoothly. Laminate flooring that swells due to moisture should be disassembled and new pieces installed.

The most common reason is lack or not enough big expansion gap around an edge of wooden floor that gap which has been covered by skirting or beading etc the common size is 10mm but best is to check floor manufacturer recommendation.